medium speed servo wire cutting machine factory faults can be determined as follows:

1. Observe the machine tool: First of all, you need to observe the machine tool itself to see whether there are deformation, wear, loosening and other problems. If the machine tool is found to have the above problems, it needs to be repaired and replaced in time.

2. Check the cutting power supply: If the machine is normal, then you need to check whether the cutting power supply is normal. You can use a multimeter to check whether the output voltage of the power supply meets requirements. If the power supply fails, replace or repair the power supply in time.

3. Check the cutting head: The cutting head is an important part of the medium speed servo wire cutting machine factory, and it is also a place prone to failure. You can check whether the joint of the cutting head is loose, whether the nozzle is blocked, and whether the guide rail of the cutting head is working properly.

4. Check the cable: The cable connection of medium speed servo wire cutting machine factory is very complicated, and if the connection is poor or the cable is aging, it may lead to machine failure. Therefore, it is necessary to check the connection of the cable regularly and replace the aging cable in time.

5. Diagnosis system: If the above methods can not solve the fault, then the entire system needs to be diagnosed. You can use the diagnostic system of medium speed servo wire cutting machine factory to check the working status and fault information of the machine, and perform corresponding processing according to the diagnostic results.

medium speed servo wire cutting machine factory https://www.talentcnc.com/Medium-speed-SERVO-wire-cutting-machine